¶ Introduction
Our Adventurer 3 is small in size but mighty in capability. It's enclosed print area and small nozzle makes it ideal for printing high quality ABS prints without warping.
A picture of our adventurer 3
¶ Recommended Uses
Our Adventurer 3 can be used for printing many different objects. It's setup to print with ABS or PLA which gives a great surface finish, and strong, structurally sound parts. Use it for printing brackets, enclosures and other small parts.
¶ Specifications
IP Address: 192.168.1.32
Usage Cost: $2/hr (50% discount for BYO filament, see staff)
Induction Class: Orange Tool (Induction Required)
Print Area: 150mm(L) x 150mm(W) x 150mm(H)
Nozzle Size: 0.4mm
Max Nozzle Temp: 240°C
Layer Heights: 0.1mm - 0.3mm
Max Bed Temp: 100°C
Supported Filaments: ABS & PLA
¶ Induction Process
This induction has one part:
- Email us to book an appointment to be inducted.
OR
Attend our introductory 3D printing class for a complete introduction. https://brisbanemaker.space/classes/
¶ How To Operate
You should be familiar with how to operate this tool after completing an induction. However, a quick reference guide is included below to assist you.
Warning: the heated bed and hot end can become extremely hot and result in severe burns if touched.
¶ Before Use
- Prepare your model by downloading or exporting it in
.stlformat. - Open the "FlashPrint" software on our iMac and import your model by clicking on "Load" and selecting your file.
- Click on "Print" then select
ABSorPLA, then select the "standard" print profile. - Click on "OK", then select "Send GCode" if you're happy with the print time.
- Watch the printer until the first layer is finished, then you can go work on something else!
¶ During Use
- Check on the printer once every 30 minutes at a minimum. If you wish to leave a print unattended, please send staff a message via Discord and confirm they are aware of your print before leaving.
- Regularly check the object has not come off the build plate and it's still printing correctly.
¶ After Use
- Wait for the print bed to cool down before removing it.
- Gently flex the print bed to release your object. You may need to use a spatula to help it off.
- Clean up all bits of loose filament / plastic from around the print area, and gently use side cutters to remove excess plastic from the print bed.
¶ Brisbane Makerspace Stocked Materials
We try to keep the following filaments in stock for members to use but check with staff ahead of time if you need something specific. Filament is included in the hourly machine cost. We recommend using these unless you have a special need, as they've been chosen to work well with our machines and have calibrated profiles. If you'd like to suggest other filaments to stock, please let us know.
¶ 1.75mm eSUN ABS+ Filament
- Black
- White
¶ 1.75mm eSUN PLA+ Filament
- Black
- White
- Red
- Marble